Band A Calculation; Chapter 3. Machine Usage Conditions; Max. Weight And Dimensions Of The Package; Items That May Be Packaged - Minipack-Torre RP40 Instructions Pour L'installation, L'emploi Et L'entretien

Chapter 2. Film features

2.2. Band A calculation

Band A = b + c + 100mm
By band "A" we mean the width that the film must have to package the product.

Chapter 3. Machine usage conditions

3.1. Max. weight and dimensions of the package

RP40 a = 400mm
RP55 a = 500mm
RP85 a = 800mm
Note: measurements shown refer to the maximum for the single dimension.
Refer to chapter 2.2. to get max. dimension of pack (b x c); the addition of (b + c) is equal to
film roll width minus 100mm.

3.2. Items that may be packaged

These machines are capable of packing a wide range of completely different products. They are used successfully in the
following sectors: food, marketing, graphics and mailing, large distribution, industry, fabrics.

3.3. Items which must not be packed

The products listed below must absolutely not be wrapped to avoid permanent damage to the machine and serious
injuries to the operator:
Wet and unstable products

Liquids of any kind and density in fragile containers

Flammable and explosive materials

Pressurised gas cylinder of any kind

Loose and volatile powders

Bulk materials with grain size smaller than the holes of the reticulated plate

Any materials and products not listed but which might harm operator and damage the machine.


Chapter 4. Safety standards

4.1. Warnings

It is extremely important to read this entire chapter as it contains important information regarding risks that personnel are
subject to in the event of incorrect use of the machine. These basic standards must be observed as well as specific
standards applicable in the country of installation.

The machine must be installed by trained and authorised technicians.

This machine is not intended for use by persons (including children) with reduced physical, sensory or mental
capabilities, or lack experience and knowledge, unless they have been given supervision or instruction concerning
use of the machine by a person responsible for their safety.

Children should be supervised to ensure that they do not play with the machine.

Never use the machine for purposes other than as specified in the sales contract.

Never allow unauthorised personnel to perform repairs or other operations on the machinery.

The operator must be familiar with all warnings related to the tasks in hand and always be informed by the head of
the site regarding risks.

Ensure that all clothing is tight fitting, with particular reference to cuffs or other loose clothing.

Ensure that all operating areas and transit zones are kept clear, clean and adequately lit at all times.

Eliminate all safety hazard conditions before using the machine and always notify the head personnel of any
malfunction.

Never use the machine in the event of fault.

Never tamper with safety devices or circuits.

Never perform modifications on the machine without prior authorisation from the manufacturer.

If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
b = 250mm c = 160mm
b = 380mm c = 200mm
b = 500mm c = 200mm
Weight = 10Kg
Weight = 15Kg
Weight = 18Kg
16
EN
EN
EN