Parkside PLSA 40-Li C2 Instructions D'origine page 31

the machine via the in-feed ap-
erture.
• If the machine becomes
clogged, turn off the power
source and disconnect the ma-
chine from the mains supply or
remove the batteries before free-
ing any refuse.
• Never operate the machine with
defective protective equipment
or shields, or without safety
equipment, e.g. without the col-
lection bag being connected.
• Keep the power source free of
refuse or other accumulated ma-
terial to prevent it from becom-
ing damaged and to avoid a
potential fire.
• Do not transport the machine
while the power source is running.
• If the cutting mechanism comes
into contact with a foreign ob-
ject or the machine starts to
emit unusual noises or vibrate,
immediately turn off the power
source and wait for the machine
to come to a standstill. Discon-
nect the machine from the mains
supply or remove the batteries
and perform the following steps
before re-starting and operating
the machine:
- investigate for damage;
- replace or repair damaged
parts;
- check for loose parts and
tighten as necessary.
• Ensure that you do not touch any
of the dangerous moving parts
before you have unplugged the
machine from the mains supply
or removed the batteries from
the machine, and that the dan-
gerous moving parts have come
to a complete standstill.
• In the case of an accident
or malfunction during op-
eration, the device must
be switched off imme-
diately. Injuries must be
properly treated or medi-
cal assistance sought. Read
the "Troubleshooting" section to
correct any malfunctions or con-
tact our Service Centre.
Maintenance and storage:
• Regularly check the functional-
ity and integrity of the device to
avoid danger to the operator.
• Replace worn or damaged parts
in the interests of safety. Only
use original replacement parts
and accessories.
• Do not try to repair the device
yourself, unless you have pro-
fessional training. All work not
mentioned in these instructions
may only be performed by au-
thorised service representatives
commissioned by us.
• Store the device in a dry place
and out of reach of children.
• Treat your device with care.
Clean the ventilation slits
regularly and follow the mainte-
nance instructions.
• Keep all inlets for the cooling air
free of debris.
• Do not use the device if the
switch cannot be turned on and
off. Damaged switches must be
replaced at a customer service
workshop. Do not overload your
device. Only work within the
power range indicated. Do not
GB IE
31