Assembling/Dismantling The Three-Piece Suction Pipe; Installing/Removing The Collection Bag - Parkside PLSA 40-Li C2 Instructions D'origine

GB IE
tion attached. There is a risk
of personal injury!
Pay attention to the correct assem-
bly of the protective cover (7), oth-
erwise the leaf blower will not start.
1. Assemble the blowpipe (9) as illus-
trated. The parts click into place.
The turbo nozzle (22) can be used
optionally (see "Working with the de-
vice"). To do this, push the tab of the
turbo nozzle (22) onto the lug on the
centre blowpipe.
2. Now push the blowpipe (9) on to the
blowing aperture of the motor housing (1)
until the blowpipe (9) latches into place.
3. Put the protective cover (7) on the suc-
tion aperture. The marking on the pro-
tective cover (7.1) and the marking on
the motor housing (7.2) must overlap.
Push the protective cover into the motor
housing until it clicks into place.
4. Dismantle the blowpipe (9) by pressing
the locking button (10) and pulling off
the blowpipe.
Assembling/dismantling
the three-piece suction
pipe
Never use the leaf vacuum
with only one suction pipe
section attached. There is a
risk of personal injury!
After the three-part suction
pipe has been assembled, it
must not be divided up again
into three parts!
Pay attention to the correct assem-
bly of the suction pipe (7), other-
wise the leaf blower will not start.
34
1. Open the protective cover (7) of the
suction aperture by pushing the lock
of the suction aperture (8) in the direc-
tion of the suction aperture, lifting the
protective cover and pulling the lock
(8) away from the suction aperture. You
can now remove the protective cover
(7).
2. Assemble the three suction pipes (16)
as illustrated.
When assembling, pay attention to
the guide grooves on the suction pipe
parts.
3. Put the suction pipe (16) onto the suc-
tion aperture, whereby the largest of
the three lugs on the suction pipe must
fit into the largest of the three gaps in
the motor housing (1). Push the suc-
tion pipe into the motor housing until it
clicks into place.
4. Dismantle the suction pipe (16) by
pressing the lock of the suction aperture
(8) in the direction of the suction aper-
ture and pulling out the blowpipe.
Installing/removing the
collection bag
In suction mode the device
must only be operated with
the collection bag mounted.
The ventilation opening on the collection
bag (20) serves for an improved air circula-
tion.
1. If necessary, remove the blowpipe
( 9) (see "Assembling/dismantling
the blowpipe").
2. Now push the collection bag (15) on to
the blowing aperture of the motor hous-
ing (1) until it latches with the locking
button (10).