Your Safety; First Operations; Unpacking - Zodiac O'Clair Pool First Notice De Montage Et D'utilisation

2-Notice Poolfirst ANG_Mise en page 1 05/01/11 11:06 Page14
The Pool First robot has been manufactured in conformity with the most demanding norms.
In order to ensure optimal and safe functioning of your swimming pool cleaner, you must
respect the following instructions:
> Only plug the control box to a power socket protected with a residual differential current
protection system of 30 mA maximum.
> Make sure that the electric plug is always easily accessible.
> The control box must not be installed in a place that is liable to flooding.
> The control box must be placed at a distance of at least 3.5 m from the edge of the
swimming pool, and should not be directly exposed to the sun.
> Never allow anyone to bathe in the pool whilst the robot is in the swimming pool.
> If the control box were to accidentally fall into the pool, unplug it from the electrical socket before
retrieving it.
> To avoid electrical shock, do not open the electronic control box. If you encounter a problem,
contact a qualified technician.
> Do not operate the robot when it is out of the water.
> Do not attempt to repair the electric power cord. Contact the after-sales service to have it
replaced by an original spare part so as to avoid danger.
> Do not use the robot in the swimming pool if the water temperature is above 35°C.
> Unplug the power cord before any cleaning, service or maintenance operation and after using
the robot.
This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by a person responsible for their safety.

UNPACKING

The packaging should contain the following elements:
> the Pool First robot; a carry cart; a control box and the user manual.
1
3
7
8
9
6
10
Figure 1

1/ YOUR SAFETY

2 / FIRST OPERATIONS

Unpack the elements as follows:
> First remove the box that is on top of the robot: it contains the control
2
box.
> Then take out the parts for the cart.
4
> 2 upper tubes: right (1) and left (2), 1 control box hook (3), 2 cable
hooks: top (4) and bottom (5), 1 hook cap (6) and one bag of screws
5
containing 2 special plastic screws (7), 4 long screws (8), 4 nuts (9) and
a spanner.
> Finally, extract the lower part of the cart (10).
Check that the device has not suffered any damage during its transport
(shocks, broken parts, etc.). if you notice any anomalies, contact your
retailer before using your robot.
Figure 1.
14