Components - Meister MPS800-1 Traduction Du Manuel D'utilisation Original

5453400-Pendelhubs_man 07.04.15 09:56 Seite 39
The specified vibration emission value
was measured in accordance with a
normed test procedure and can be used
in order to compare one electrical tool
with another.
The specified vibration emission value
can also be used for an introductory
evaluation of the exposure.
NOTICE! The vibration emission
value may fluctuate from the
specified value during use of the
electrical tool. These fluctuations will
depend on the way in which the tool
is used.
Information about minimising
vibrations
Warning: The actual vibration emission
value present during the use of the
machine may deviate from the
specification given in the operating
instructions or made by the manufacturer.
This may be caused by the following
influencing factors that should be taken
into account prior to and during each use:
• Is the device being used correctly?
• Is the correct type of material being
processed?
• Is the device in proper working order?
• Are the handles or optional vibration
handles mounted and fixed securely
up against the body of the machine?
If you experience an unpleasant
sensation in your hands or the skin
changes colour while you are using the
machine, immediately interrupt your
work. Take sufficient breaks. If you do
not take sufficient breaks, this may
cause a hand-arm vibration syndrome.
You should estimate the level of load
caused in conjunction with the work or
use of the machine and take the
appropriate breaks. This method can be
used to considerably minimise the level
of load during the entire working time.
Minimise risks in which you are exposed
to vibrations. Take care of your
machinery in accordance with the
directions in the operating instructions.
If the machine is to be used frequently,
contact your dealer and arrange anti-
vibration equipment (handles) if necessary.
Avoid using the tool in temperatures of t
= 10 °C or lower. Draw up a working
schedule which can be used to
minimise vibration loads.
Warning: A certain amount of noise is
unavoidable when using this device.
Ensure you carry out noise-intensive
work during permitted times. Maintain
the quiet periods and limit your work to
the absolute minimum. For the sake of
your personal protection and the
protection of persons in the vicinity,
suitable ear defenders should be worn.
3 – Components
1 Stroke rate pre-selection
(adjustment wheel)
2 Locking button
3 On/Off switch
4 Connection cable
5 Connection for dust extractor
6 Selection switch for dust blower
function
7 Saw shoe with plastic sliding plate
8 Cutting angle setting
9 Pendulum
10 Guide roller
11 Saw blade holder with quick change
system
12 Cut protection guard
39