DigiSender X7 Mode D'emploi page 17

ENGLISH
DG440 - DigiSender® X7
TROUBLESHOOTING
Remote Control Extender
If you have any difficulty operating your source equipment remote control in
your second room please follow the advice below below:
1) Ensure the IR Systeme Technik™ IR Emitter is connected to the DigiSender®
transmitter.
2) Ensure you are using the correct remote control in the second room. For
instance, if you are trying to control your satellite channel you will need to use
the satellite remote control.
3) Ensure the IR Systeme Technik™ IR Emitter is facing the remote sensor on your
source equipment.
4) Move the IR Emitter further away from the source equipment using the
supplied extension accessory.
5) Move the transmitter AND receiver further away from other electrical devices.
6) Choose a new remote relay channel taking care that the same channel is
selected on both transmitter and receiver.
7) Operate the remote control closer to the DigiSender® receiver.
8) Replace the batteries in the source remote control.
Please read this instruction manual carefully prior to installation Page 17