DigiSender X7 Mode D'emploi page 10

DG440 - DigiSender® X7
continued...
Did you know? The receiver can be connected to a Hi-Fi unit using
the Left & Right Audio outputs on the rear of the DigiSender®receiver unit.
Phono cable may be required.
STEP 4
Connect the power supply unit to the socket
labelled PSU.
STEP 6
Page 10
STEP 5
Connect the power supply unit (PSU) to an
available wall socket.
Press the POWER button on your DigiSender
remote control to switch the receiver on. The
power LED will be green to indicate the device is
switched on.
Switch on the second television and select it's
SCART channel. This will be labelled on the
remote control as one of the following buttons:
AV, VIDEO, VCR, AUX, SCART,
EXT, 0
Refer to your tv's manual for further assistance.
Online Support at www.digisender.net