Publicité
Les langues disponibles
Les langues disponibles
Hidden Helpers
Instruction
. A Stacked installation. Attach the
enclosed anti-tilt protection to the
washing machine and the dryer.
Push the upper part of the anti-tilt
protection into the dryer until it
hooks into place. Screw the lower
part into place with the screws you
removed from the washing machine
(A).
If the machines are set right against
the wall, the dryer cable must be
routed through the cutout on the
middle section (B).
. B Installation on washing machine
or tumble dryer. Attach the enclosed
anti-tilt protection as illustrated.
Screw them into place with the
screws you removed from the
washing machine (A).
Note!
Check that the edges of the spacers are lined up carefully with the edges of the washing machine and
tumble dryer before you screw the anti-tilt device in place.
Installation of spacer on machines that have been stacked
Note: The spacers must only be used with washing machines and tumble dryers manufactured by Asko
Appliances, Sweden.
Instruction
1. Remove the anti-tilt device, which
is no longer needed. Lift the tumble
dryer down.
. Put the spacers on the washing
machine. Make sure that the edges
of the spacers are lined up carefully
with the edge of the washing
machine panel.
. Screw out the feet of the tumble
dryer turns from their fully
screwed-in position.
Then lift up the tumble dryer. Put the
back feet of the tumble dryer in the
"keyholes" in the spacer and slide
the tumble dryer backwards. Put the
front feet down in the holes.
Picture
B
Picture
A
Publicité
