Olimpia splendid ASTOMI 80 Instructions Pour L'installation, L'emploi Et L'entretien page 30

8 - TROUBLESHOOTING GUIDE
PROBLEM
The appliance does not work. Power plug: Disconnect it from the power outlet and plug it in again.
Air blows but water vapor is
not produced.
Humidity level is low.
The humidity has a bad smell. Poor maintenance or dirty water: Accurately clean the reservoir and
White powder is formed near
the appliance.
The appliance has stopped
working.
Water accumulates outside
the appliance or around it.
The appliance will not start.
POSSIBLE SOLUTION
Power Failure: When the power is returned, try again.
There may be oil residues in the reservoir; wash the reservoir and
try again.
The surface of the ultrasonic disk is dirty: Clean ultrasonic disk
(Fig. L).
If you use hard water, replace with softer water.
The surface of the ultrasonic disk is dirty: Clean ultrasonic disk
(Fig. L).
The water in the unit is too cold: Replace with cool, but not cold
water.
fill it up with clean water.
Hard water may deposit a certain of dust. Dust in the air also settles
because of added humidity in the room. Use distilled water if this
becomes a nuisance.
Little or no water. Unplug the appliance and fill up the reservoir.
Humidity saturation. Lower the mist control setting.
Point the nozzle away from objects. Lift the appliance onto a wa-
ter-resistant levelled surface at least 60 cm above the floor.
Too much water in the reservoir. Do not exceed the MAX marking.
EN- 14