Publicité
Les langues disponibles
Les langues disponibles
The appliance must be installed so that the switches and other controls
–
can not be reached by persons using the bath tub or the shower.
If the power cable is damaged, it must be replaced by the manufacturer,
–
an authorised service centre or a qualified electrician in order to eliminate
all risk.
The appliance must not be positioned directly underneath a fixed power
–
point.
Do not cover the appliance while it is functioning to avoid overheating
with the attendant risk of fire.
Do not use the appliance in rooms less than 4m2 in area.
–
The heater is fitted with a safety device which will switch off the heater in
–
case of accidental overheating (eg. obstruction of air intake and outlet
grilles, motor turning slowly or not at all). To reset, disconnect the plug from
the power for a few minutes, remove the cause of overheating then plug
the appliance in again.
WARNING: To avoid overheating, never under any circumstances cover the
appliances during operation, as this would lead to dangerous overheating.
CAUTION: To avoid a hazard due to inadvertent resetting of the thermal cut-out,
this appliance must not be supplied through an external switching device, such
as a timer, or connected to a circuit that is regularly switched on and off by the
utility.
Overview of the components
1. Handle
3. Function switch
Electrical Connection
Before plugging in the heater, check that the voltage of your domestic
–
supply corresponds to the voltage (V) indicated on the appliance.
Check that the electrical socket has a rating of 10/16 Amps.
–
Use
INSTALLATION
The appliance requires no installation; it should be used solely as a portable
appliance. Portable appliances are not suitable for use in a bathroom.
OPERATION
–
Turn the thermostat knob (2) in a clockwise direction until it reaches the
maximum setting.
Instructions for use
2. Thermostat
4. Pilot lamp
English
3
Publicité
