Amplicomms RingFlash 250 Mode D'emploi page 28

Using the RingFlash 250
Interference through other equipment
Under certain circumstances, other
electrical equipment can cause interfe-
rence to the RingFlash 250. You can alter
the access code of the RingFlash 250
and pick-up as follows:
1. Remove the small cover on the underside
of the RingFlash 250 base station.
2. Change the setting of the 8-position DIP
switch, illustrated below, as necessary.
ON
1 2 3 4 5 6 7 8
3. Remove the cover of the pick-up housing
as described on Page 25.
4. Change the setting of the 8-position mini
DIP switch according to the settings
programmed on the RingFlash 250 base
station.
5. Replace the cover of the pick-up housing
as described on Page 25.
28
Battery charge
Vibration alarm
DP
The Status LED (1) of the respective pick-
critical charge level. If the Status LED (1)
the 23A battery. If the Status LED (1)
the CR2 battery.
You can insert a vibration pad (not con-
tained in the material supplied) in the con-
nection socket (13) on the rear side of the
RingFlash 250 base station. If a signal
is received, the vibration pad begins to
shake.
You can use suitable screws and wall
dowels (not contained in the material
supplied) to mount the RingFlash 250
base station, via the holes in its base, on
a wall.