Amplicomms RingFlash 250 Mode D'emploi page 24

Using the RingFlash 250
Settings on the RingFlash 250
base station
After connecting the RingFlash 250 base sta-
for the signal alarm. These settings include
the type of signal alarm, melody for the signal
alarm and volume of the signal alarm.
1. To begin, move the volume slide control
(14) to a low volume (slide the control to
the left).
2. Initiate a test call in order to test the vo-
lume of the signal alarm and then set the
volume to the level required.
If you have not connected a phone to the
RingFlash 250 base station, do not com-
plete the volume adjustment for the signal
alarm until you have connected a pick-up
to the RingFlash 250 base station.
24
3. Select the type of signal alarm required
using the sliding switch (15).
4. By moving the slider from left to right,
you can select from the following types of
light and acoustic signal without vibration,
no signal enhancement. (Also refer to
Page 29 Quick function overview)
5. The sliding switches for selecting the
melodies (8+9) can be used to select one
melody for the signal alarm of the pick-up
(9) connected to the RingFlash 250 base
station and one melody for the signal
alarm of the telephone (8) connected to
the RingFlash 250 base station. (Also
refer to Page 29 Quick function overview.)