S&P COR-1000 NW 9 Notice D'installation Et D'utilisation page 10

The connection can be made either through the back or by the side of the units. In case of connection by the
side, the lid of the connections must be mounted through the cable before carrying the connections.
Fix the cable with the clamp provided and mount the front cover.
OPERATION
REMOTE CONTROL CONNECTION CR-NW
(This control is incorporated in the packaging of each air curtain)
IF CONNECTION BETWEN TWO OR MORE AIR CURTAINS OF THE SAME MODEL (MAX. 5 UNITS), PLEA-
SE REFER TO WIRING DIAGRAM FROM FIG. 6.
NOTE: In the case of multiple connection, Installer must consider the increased number of feeders based on
the number of connected units. In order to interconnect two or more curtains it is predicted that the cables
can go through their interior. FIG. 7 shows a lateral cover on which a noticeable circular opening is present.
This opening allows easy breakage, thus enabling the installer to feed cables to the unit.
MAINTENANCE
The COR Air Curtains do not need any special maintenance, but it is recommended to keep the inlet and
outlet grilles clean. Clean them with a dry cloth (avoid using solvents or abrasive
detergents). Once a year, the inside parts should be cleaned by a qualified electrician using compressed air or
a vacuum cleaner. Disconnect the unit from the mains supply before carrying out this operation.
In order to carry out any maintenance tasks, the omnipolar cut-off device must be activated to ensure that
none of the parts inside the apparatus are live.
AFTER SALES SERVICE
In case of any problem with the unit, it is advised to contact your S&P dealer. Any manipulation of the applian-
ce by personnel not appointed by S&P will cancel the guarantee.
S&P reserves the right to modify the product without prior notice.
10