Publicité
Les langues disponibles
Les langues disponibles
Installation Instructions
1) Battery Disconnection:
Disconnect the vehicle battery observing the normal battery disconnection procedures and
remove the vehicles radio assembly.
Refer to vehicles workshop manual for further information and ensure any radio or alarm codes
etc are noted before disconnection.
2) Component Location:
The recommended component locations can be found in the vehicle specific information section
later in this manual but as model specifications can change, the following general observations
and mounting procedures should be made when choosing positions and fixing the components:
2.1 - Control unit location:-
Secure the control unit in the chosen location using the adhesive velcro patch or the cable
ties provided in the kit.
When using the velcro, ensure the surfaces are clean by using the alcohol swab provided in
the microphone kit.
- Do not locate the control unit in any metallic surround as this may shield the
Bluetooth communication
- Chose a location for the control unit which is away from any direct source of
extreme heat or moisture.
2.2 - Control button location:
The control button should be mounted within easy reach of the drivers position.
Use the self-adhesive template provided in the kit to determine the exact hole position and
with it positioned in the chosen location, carefully drill the 24mm hole to accommodate the
switch assembly.
De-burr and rough edges before fitting the switch and securing with the locknut provided.
IMPORTANT:
It is ESSENTIAL when choosing a switch location that extreme care is taken BEFORE drilling
and by considering the following questions:
- What is behind the trim panel and would it be safer to remove it to ensure there
is sufficient space for the depth of the switch?.
- With the switch fitted, will it foul any other equipment behind the trim panel when
it is replaced?
- Is it necessary to remove the trim panel to ensure the locating hole can be
drilled squarely with no risk of the drill interfering with anything else - wiring
harnesses etc?
- 4 -
Publicité
