Troubleshooting - Husqvarna 545FR Manuel D'utilisation

To adjust the product for cold environments
If the temperature is 5°C/41°F or colder, adjustments are
necessary to prevent operation problems.
• Attach the air duct as shown in the illustration. Make
sure that the arrow points in the direction of the
winter mode symbol.
• If you operate the product in snow or below 5°C/
41°F, attach a cover on top of the starter.
CAUTION: Do not operate the product at
temperatures of more than 5°C/41°F if it is
adjusted for winter mode. The engine
becomes too hot and can be damaged.
Make sure that the winter mode adjustments
The engine does not start
Check
Stop switch.
1018 - 005 - 08.06.2020
To lubricate the wire
545FXT
Note: The wire is lubricated at the factory. Lubricate the
wire when it is necessary.
1. Remove the protective cover.
2. Remove the cylinder cover to get access to the
3. Make sure that the rubber bellows does not expand.
4. Remove the plug on the grease nipple.
5. Use antifreeze spray with a 2 mm spray tube. Spray
6. Attach the cylinder cover and the protective cover.

Troubleshooting

Possible cause
The stop switch is in the stop posi-
tion.
are removed before you operate the product
at temperatures more than 5°C/41°F.
rubber bellows on the wire.
with short intervals.
Procedure
Let an approved servicing dealer re-
place the stop switch.
27