Publicité
Les langues disponibles
Les langues disponibles
MANUAL
To set up middle-layer:
1. Set up playard. Hang the hooks tight aroud the rails. Smooth the
fabric for the middle layer support. (fig 11).
2. Put short iron pipes into holes at the bottom of the middle-layer
support join corresponding ones together to open the crib fully. (fig
12).
3. Unfold the mattress, put it into playard. Make sure it has been laid
on the right position. (fig 13).
Your middle-layer support is now ready for use.
To set up changing unit:
1. Put small pipe into big one, ensure spring locks the loop. (fig 14).
2. Hang diaper tray on visible pipe of the one shorter top rail. (fig 15).
3. Turn diaper tray and level it, press down two plastic slices on the
two longer top rails. (fig 16).
To fold playard:
1. Undo velerco straps, remove and site aside floorboard and cover
sheet; grab center floor support loop and rise approximately twelve
inches with a slight jacking action. (fig 17).
2. Push the button, which are located at the exterior sides of the
center of the four top rails. (fig 18).
3. Gather the playard frame together as you pull up on the center
floor loop. (fig 19).
Make sure when compacting frame that the two shorter "V" shaped rails (D) are
pointing slightly inward and the londer "V" shaped rails are pointed slightly outward (E)
(fig 20)
NOTE :
The above step must be done properly for playard to fit in travel bag.
1. Wrap floorboard around the playard frame with the sheet and soft-
side next to the playard frame. (fig 21)
2. Secure velero labs through loops on end of floorboard (fig 22)
3. Put carrying bag over playard as started so carrying handle come
through opening (fig 23 en 17).
Publicité
