Publicité
Les langues disponibles
Les langues disponibles
MANUAL
GB
NIDO GIRAFFE LUX
ASSEMBLY GUIDELINES
To set up playard:
1. Unzip travel bag and remove contents, stand-up playard assembly
so floor loop (A) is on top and feet (B) are in the bottom (fig 1).
2. Undo the three velero straps [C] that secure the playard frame (fig
2), put floorboard aside.
3. Separate legs to be approximately two feet apart (fig 3).
4. Keep the center being up about half of the leg's height, expand the
two shorter top rails by holding the rail locks and pulling upward to
make the top rails been locked and straight up completely (fig 4).
5. Then do the same for the two longer top rails (fig 5).
NOTE
A)Please double check if all four top rails been locked completely to
avoid danger happened
B)Rail locks are located in the center of the top rails and are completely
enclosed within top fabric
6. After all the four top rails are locked and straight up completely,
then push down on center of playard floor until it locks into flat
position. (fig 6)
7. Place floorboard in playard (fig 7).
8. Secure floorboard to playard frame by passing the four velero
straps (fig 8) through the four holes in the bottom of playard (fig 9)
and securing velero (fig 10).
Your playard is now ready for use
Care instructions:
floorboard sheet:
Machine wash, cold water delicate cycle, umble dry on low heat. Do not
wash with other clothing.
Carrying bag:
Hand wash, cold water mild detergent, drip dry.
Playard and floorboard:
Spot clean with mild household detergent and water, drip dry.
Publicité
