Changing The Exhaust Direction; Using The Nose Cap - Metabo HPT NT 50A5 Manuel D'instructions

English

CHANGING THE EXHAUST DIRECTION

● When changing the exhaust direction, be
sure to remove your fi nger from the trigger
and disconnect the air hose from the nailer.
The direction of the exhaust vent can be changed by
turning the top cover.
Exhaust vent

USING THE NOSE CAP

● When detaching or attaching the nose cap,
be sure to remove your fi nger from the trigger
and disconnect the air hose from the nailer.
The nose cap is attached to the push lever tip to protect
the workpiece from scratches or damage. Remove in the
order shown below when not using.
1 DISCONNECT AIR HOSE FROM NAILER.
2 Pull out the nose cap in the direction of the arrow as
shown in the diagram.
○ Attach to the tip of the push lever in the reverse order
of detaching.
Firing head
Push lever
Nose cap
When not using the nose cap, attach to the storage area
in back of the magazine.
18
WARNING
Top cover
WARNING
1 Disconnect
air hose
Nose cap
USING THE HOOK
● When attaching or detaching the hook, make
sure the hose is detached and the nails are
removed from the tool.
● When the hook is attached, operate only
with SINGLE SEQUENTIAL ACTUATION
MECHANISM
ACTUATION MECHANISM. For switching
between SINGLE
CONTACT, see the appropriate section in
"METHODS OF OPERATION".
● Disconnect the air hose when hook the unit.
● Do not hook on high or unstable locations.
Also, do not hook it to the body, clothing, belt
or other personal items.
The hook can be attached to the right or left of the tool.
When changing the position of the hook, remove the
screw with a Phillips head screwdriver, change the
position of the hook to the desired direction, and re-attach
the screw.
Hook
WARNING
and not with CONTACT
SEQUENTIAL
Hook
and