Adjusting Air Pressure - Metabo HPT NT 50A5 Manuel D'instructions

ADJUSTING AIR PRESSURE

Adjust the air pressure
operating pressure 70 – 120 psi (4.9 – 8.3 bar
5 – 8.5 kgf/cm ) according to the length of nails and the
2
hardness of workpiece.
The correct air pressure is the lowest pressure which will
do the job. Using the Nailer at a higher than required air
pressure unnecessarily over stresses the Nailer.
LOADING NAILS
● When loading nails into Nailer,
1) do not pull trigger;
2) do not depress push lever; and
3) keep Nailer pointed downward.
(1) Lightly press the stop lever and gently pull out the
magazine cover.
Magazine cover
(2) Set nail strip into the magazine and keep the points of
nails in contact with Groove.
Nail strip
NOTE
● The nails shown in page 9 can be loaded onto the
side guide groove of the magazine without any
adjustment.
Always keep the points of nails in contact with
Groove.
WARNING
● Do not exceed
120 psi (8.3 bar
8.5 kgf/cm
at recommended
WARNING
Press
Pull out
Stop lever
Groove
Magazine
Side guide
groove
Nail
).
2
(3) Slide the nail strip into the blade guide.
(4) Confi rm that nail strip is placed with side guide
grooves and Groove properly, then push the
magazine cover forward to be latched.
NAILER OPERATION
Read section titled "SAFETY"(pages 3 – 7).
● Know and understand what trigger system you
are using.
Please read and understand "Methods of
Operation" below.
Magazine
Gap
Groove
Nail strip
Blade guide
DANGER
● Operators and others in work
area MUST wear
glasses with side shields
which conforms to ANSI Z87.1
specifi cations.
Ordinary eyeglasses do not
provide adequate protection.
WARNING
● Only person who have read
and understand this MANUAL
should operate the Nailer.
● NEVER point tool at yourself
or others in work area.
● Keep fi ngers AWAY from
trigger when not driving nails
to avoid accidental discharge.
English
safety
13