Built-In Drawings - Gastros InductWarm 130+ Mode D'emploi

USB connection
Both software updates and system parameter updates can be loaded via the USB port. This task should only be
performed by trained service staff.
Cleaning / maintenance
The InductWarm 130+ is intended to be installed underneath a cover plate and is normally operated via an
®
external control panel. Daily cleaning of the device is therefore not necessary. The cover must be designed in such
a way that no liquids can get to the induction device. For general maintenance and cleaning work on the buffet
counter, the entire counter must be disconnected from the power supply.
The device must be protected against water splashes and must not be cleaned with a water jet.

Built-in drawings

Assembly instructions for one device
Cover plate (note cover material guidelines)
InductWarm 130+
®
Recess
cover material
Counter
29