Zanussi THE 4750 Notice D'utilisation page 59

audible confirmation of:
• cycle end
• anti-crease phase start and end
• cycle interruption
• error
DELAY START
allows to delay the start of a drying programme: 3
or 6 or 9 hours
1. select the drying programme and additional
drying options
2. press the DELAY START button repeatedly
until the desired delay start is chosen
3. to activate the delay timer, press the Start/
Pause button
Starting the programme
Press Start/Pause button to start the dryer
after having selected the programme and the
options. The relevant light will stop flashing. If
the programme selector dial is turned to anoth-
er position, when the machine is running, the
buzzer will sound and the programme phase in-
dicator lights will flash. The drum turns alter-
nately in both directions during drying.
All drying programmes end with a 10 minute
cooling phase. You may remove the laundry af-
ter this phase.
If the door of the appliance or the small door at
the bottom is opened while the programme is
running, this button must be pressed again af-
ter closing the door in order to restart the pro-
gramme from the point at which it was interrup-
ted. This button must be depressed also after a
power failure and after having reinserted the
water reservoir, if it has been emptied in the
middle of a programme after lighting up of light
Water reservoir.
In both cases the light of the
button flashes to remind you that the start but-
ton needs to be pressed again.
Indicator lights
These lights indicate the following functions:
•
Drying light: This light indicates that the
appliance is in the drying phase.
4) Only dryers with buzzer button
www.zanussi.com
•
•
•
•
Changing programme
To change a programme which has been selec-
ted by mistake once the programme has star-
ted, first turn the programme selector to
OFF position. The programme is cancelled.
nevertheless there is an attempt to change the
programme on the programme knob or if an
function button (excluding the
ton
button starts flashing temporarily in red. The
drying programme is not however affected by
this (laundry protection).
At the end of the programme
If the laundry is not removed at the end of the
Start/Pause
cycle, the dryer performs an anticreasing phase
(duration: 30 minutes maximum).
If you do not remove the laundry, the dryer will
stop automatically at the end of the anticreas-
ing phase. Lights
sounds for 2 minutes.
End of programme light: This light is on
at the end of the cooling phase, during the
anticreasing phase and at the end of the pro-
gramme.
Water reservoir light: This light indi-
cates that the appliance is in the drying
phase. This light comes on at the end of the
programme to remind you that the water res-
ervoir must be emptied out. If this light illumi-
nates during a programme this means that
the water reservoir is full. The buzzer sounds,
the programme stops, the light of the Start/
Pause button flashes. This light comes on al-
so when the water reservoir is not inserted
correctly.
Filter light: This light illuminates at the
end of the programme to remind you that the
filters must be cleaned.
Condenser light: It comes on every 3 cy-
cles to remind you that the condenser must
be cleaned.
The programme can no longer be changed
directly once the programme has started. If
4)
) is pressed, led on the
End of programme , and
Water reservoir remain lit and the buzzer
-
BUZZER but-
START/PAUSE
59