Gaggenau VL 414 110 Notice De Montage page 11

Installation Procedure
Installation of control console
Note: Only install the appliance in conjunction with the
corresponding control console.
1 Remove the packaging of the control knobs and the
protective film from the light rings.
2 Hold the bracket against the front panel from the
rear. Insert the control knob in the holes from the
front and screw it down it from the rear with the nut.
In s t a l la t i o n P r o c e d u r e
3 Using the screws included, bolt down the control
panel on the bracket.
9
CAUTION
Appliance damage! Establish equipotential
bonding. Before the control cables may be
plugged onto the control panel, the stranded
grounding wire from the control unit must be
fitted on the control panel.
11