Installing The Door Handle - Summit SWC1127B Mode D'emploi

Installing the Door Handle

This cooler includes one stainless steel handle that is not installed by the factory.
NOTE: The door handle is packaged inside, between the inner foam and the outer box. Do not
discard packaging until you have removed the handle.
To install the handle please follow these instructions:
1. Pull the door gasket (1) away from the door where the handle is to be installed, as shown in the
first illustration below. The gasket is easily displaced by hand, no tools are necessary.
2. Align the handle (2) with the screws pre-installed on the backside of the door. Tighten the screws
using a Phillips head screwdriver until the handle sets both flush and secured tightly against the
door frame. (DO NOT over-tighten as this will cause damage to the handle assembly).
3. Replace the door gasket to its original position.
10