Maintenance And Inspection; Service And Repairs - Hitachi FDV 16VB Mode D'emploi Et Instructions De Securite

English

MAINTENANCE AND INSPECTION

WARNING:
Be sure to switch power OFF and disconnect the plug from the receptacle
during maintenance and inspection.
1. Inspecting the driver bit
Since continued use of a worn driver bit will damage screw heads, replace the driver bit
as soon as excessive wear is noticed.
2. Inspection the drill bit
Continued use of a worn and/or damaged drill bit will result in reduced drilling efficiency
and may seriously overload the drill motor. Inspect the drill bit frequently and replace it
as necessary.
3. Inspecting the mounting screws
Regularly inspect all mounting screws and ensure that they are properly tightened.
Should any of the screws be loosened, retighten them immediately.
WARNING:
Using this hammer drill with loosen screws is extremely dangerous.
4. Maintenance of the motor
The motor unit winding is the very "heart"' of the power tool. Exercise due care to ensure
the winding does not become damaged and/or wet with oil or water.
5. Inspecting the carbon brushes
For your continued safety and electrical shock protection, carbon brush inspection and
replacement on this tool should ONLY be performed by a HITACHI AUTHORIZED
SERVICE CENTER.

SERVICE AND REPAIRS

All quality power tools will eventually require servicing or replacement of parts because of
wear from normal use. To assure that only authorized replacement parts will be used, all
service and repairs must be performed by a HITACHI AUTHORIZED SERVICE CENTER,
ONLY.
NOTE:
Specifications are subject to change without any obligation on the part of the HITACHI.
16
All manuals and user guides at all-guides.com