Installation Positioning And Connecting; Description Of The Device - BORETTI BWK-45 IX Notice D'emploi

Installation
Positioning and connection
Unpacking
1 Unpack the device immediately and make
sure it has not been damaged during trans-
port. Should it be damaged, do not connect,
and get in touch with the Dealer.
2 Carefully remove the protections and the ad-
hesives, open the door and make sure all the
components are present.
3 Take out the power supply cable.
Positioning
1 Position the device in a well ventilated area,
not damp and free (avoid cabinets with clo-
sed walls).
2 Keep the device away from heat sources.
3 Make sure the minimum distances between
the device and the walls of the room where it
is placed are kept, in order to ensure perfect
ventilation of the device.
See figure.
Ventilation space:
at least 50 mm
Wiring connection
After transport, stand the device vertically,
and wait for at least 3 hours before connecting
it to the wiring system. Before putting the plug
into the power socket, make sure that:
• the socket is earthed and according to legal
regulations;
• the socket is able to hold up to the maximum
power load of the machine, indicated on the
Data Sheet table or on the feature plate to
the bottom right (see Description of the de-
vice);
• the power supply voltage falls within the
range indicated on the Data Sheet table or
on the feature plate to the bottom right (see

Description of the device);

• the power socket is compatible with the plug
of the device. Otherwise, replace the socket
or the plug; do not use extensions or multiple
sockets.
560
min.
Dimensions of the
compartment
560 min.
560
560
540
Furniture side area
587
587
560
min.
560
min.
560 min.
560
560 min.
Dimensions
of the cellar
540
NL
FR
ES
EN
29