Clatronic AE 2895 Profi Cook Mode D'emploi & Garantie page 32

GB
1. Please attach the juice container (6) to the motor unit in such a way that the
spout is located in the recess and fl ush with it. Now insert the centrifuge sieve
(5) into the juice container. WARNING! This is sharp!
2. Please put the attachment (4) in place and lock the two safety catches (8) on
the sides in place so that they engage into the housing accordingly.
3. Push the pomace container (10) on to the device. Ensure that the pomace
container locks into place.
4. Connect the machine to a properly installed power socket, 230 V, 50 Hz.
5. Please ensure that the multiple contact switch (9) is set to „O".
6. Place a glass or other suitable vessel under the spout of the juice container.
Press the spout downwards in order to open the outlet aperture.
7. If necessary peel, stone and cut the fruits from which the juice is to be ex-
tracted into strips or pieces. Please note that this device is not suitable for re-
moving the juice from bananas, peaches, apricots etc, as these fruits contain
only very little juice. Fruits which are very hard, such as coconuts, cannot be
placed in this machine as the centrifuge sieve or the motor may be damaged.
8. Push the fruits into the fi lling aperture and insert the stopper (1). In order to make
it easier to fi ll the machine, attach the fi lling tray (2) to the fi lling aperture (3).
9. Switch on the device. Press the fruits lightly with the stopper.
10. There are 2 speeds available.
11. For removing the juice at an even speed (continuous operation):
During operation on levels 1 and 2 the switch locks in the respective position.
In order to switch off the device, turn the switch back to „O".
CAUTION: Do not use the device for more than 5 minutes!
12. The juice now fl ows into the vessel. The fl esh of the fruit is collected in the
pomace container (10). In order to avoid malfunctions please do not overfi ll
the juice container.
13. Before removing the vessel, press the spout upwards in order to close the
outlet of the juice container and avoid drips.
14. In order to release the attachment (4), press the two safety catches at the
same time and then lift the attachment off.
Mains lead take-up (11)
The mains lead can be wound up on the base.
1. Before cleaning remove the mains lead from the socket.
2. For cleaning the outside of the machine use only a damp washing-up cloth.
Never immerse the housing with motor in water!
32
Operation
Level 1 = low speed
Level 2 = high speed
Cleaning and storage