Philips HD7853 Mode D'emploi page 23

2 Rinse the water reservoir.
3 Fill the water reservoir with fresh tap water and place it back onto
the coffee machine.
Note: Do not refill the water reservoir with used hot water or the used
descaling mixture.
The machine is ready for the rinsing cycle when the on/off light lights
,
up continuously.
4 Press the 1-cup button q/f and the 2-cup button qq briefly at the
same time to start the rinsing cycle.
, The CALC light and the light ring around the on/off button start to
flash slowly to indicate that the rinsing cycle has started. The rinsing
cycle takes approx. 5 min.
When all the water in the water reservoir has been used up, the
,
rinsing cycle is finished and the appliance switches off automatically.
5 Remove the Calc-Clean tool from the coffee spout.
Note: You cannot brew coffee if the Calc-Clean tool is still in the coffee spout.
When you press the 1-cup button q/f or the 2-cup button qq to brew
coffee, the CALC light flashes to warn you that you still have to remove the
Calc-Clean tool.
6 Remove the used pod and clean the pod holder after descaling to
prevent the sieve in the centre from getting clogged.
EnglisH
23