Accessories - Samsung NK36R5000AA Manuel D'instructions Et D'installation

Range Hood Use and Care

Accessories

For non-vented (recirculating) installation only
NOTE
To reduce the risk of fire or shock when the hood is used in recirculation
mode, use only the conversion kit models listed below:
Recirculating kit: NK-AF020FNB/AA
Charcoal Filter Replacement kit: NK-AR040FNB/AA
To attach the recirculation kit, follow these steps:
1. Assemble the air deflector with the duct cover bracket with 2 -
assembly screws provided with the Recirculation Kit.
D
B. 2.9 x 6.5 mm screws
2. Measure from the bottom of the air deflector to the bottom of the
hood outlet.
B
D
E
C. X = length to cut vent duct
3. Cut the duct to the measured size (X).
4. Remove the air deflector.
5. Slide the duct onto the bottom of the air deflector.
6. Place the assembled air deflector and duct over the exhaust outlet
from the hood.
7. Re-attach the air deflector to the duct cover bracket with 2
assembly screws.
8. Seal the connections with vent clamps
10 English
A
B
C
A. Vent cover bracket
C. Deflector
A
X
C
A. Air deflector
B. Vent clamp
D. Vent duct
E. Exhaust outlet
Charcoal filter
The charcoal filter is not washable. It should last up to 6 months
with normal use. Replace with Charcoal Filter Replacement Kit.
To replace charcoal filter:
1. Remove the metal grease filter from the range hood.
2. Bend the spring clips away from the metal grease filter.
3. Place the charcoal filter into the top side of metal filter.
4. Insert the metal grease filter back into the range hood.
Range Hood for ADA Compliance