Table des Matières
Publicité
Speaker preparation (continued)
HT-SB400
ENGLISH
To mount the speaker on the wall.
Caution:
Be very careful to prevent the speaker [2.15 kg (4.74 lbs.)]
from falling when mounting on the wall.
Before mounting, check the wall strength. (Do not put on the
veneer plaster or whitewashed wall. The speaker may fall.) If
unsure, consult a qualified service technician.
Mounting screws are not supplied. Use appropriate ones.
Check all wall mount angle screws for looseness.
Select a good location. If not, accidents may occur or the
speaker may get damaged.
SHARP is not responsible for accidents resulting from
improper installation.
Driving screws
SHARP designed the speakers so you may hang them on the
wall. Use proper screws (not supplied). See below for size and
type.
5 mm
(3/16")
Min. 22 mm (7/8")
E-7
3.2 mm (1/8")
9 mm (3/8")
Wall mount angle fixed to the wall
(Horizontal position)
1
Fix the pattern paper to the wall in horizontal position
as below.
509 mm
Wall surface
44 mm
29 mm
2
Make a hole on the wall following the screw point
marks on the pattern paper by using a drill.
32 mm (1 - 1/4")
8 - 9 mm (3/8")
Wall surface
3
Fix a wall mount plug into the hole using a hammer,
until it is flush with the wall surface.
32 mm (1 - 1/4")
8 - 9 mm (3/8")
Wall surface
44 mm
29 mm
Pattern paper
continued to the next page
Publicité
Table des Matières
