Disposal; Troubleshooting - RIDGID 122 Mode D'emploi

Disposal

Parts of the 122 and 122XL Copper Cutting and Prep
Machines contain valuable materials and can be recycled.
There are companies that specialize in recycling that
may be found locally. Dispose of the com ponents in com-
pliance with all applicable regulations. Contact your local
waste management authority for more information.
For EC Countries: Do not dispose of elec-
trical equipment with household waste!
According to the European Guideline 2002/ -
96/ EC for Waste Electrical and Electronic
Equipment and its implemen tation into nation-
al legislation, electrical equipment that is no
longer usable must be collected separately and disposed
of in an environmentally correct manner.

Troubleshooting

SYMPTOM
Excessive vibration dur-
ing operation.
Machine not cutting
tubes properly.
Machine stalls while cut-
ting.
Excessive tube burrs or
end deformation.
999-998-069.10_REV. C
POSSIBLE REASONS
Cutting bent tubes on machine.
Long tubes not properly supported.
Machine not properly mounted.
Worn blades or cutter wheel.
Use on incorrect tube size or material.
Applying excessive force on the handle while cutting.
Worn or damaged cutter wheel.
Applying excessive force on the handle while cut-
ting.
122/122XL Copper Cutting and Prep Machines
Do not cut visibly bent tubes on machine. Use
hand cutter, or straighten tubes before cutting.
Support longer tubes with pipe stands.
Properly mount the machine on flat surface, bolt
with the mounting bolts.
Replace worn blades or cutter wheel.
Use on correct type of tubes (see Specifications).
Gently apply force on the handle.
Replace cutter wheel.
Gently apply force on the handle.
SOLUTION
13