Corghi ERCO HC3502 B Manuel D'utilisation page 66

Installing the power unit
E+D
66
•
Mount the support bracket of the power unit and fix it to the part of the hydraulic
power unit with screws
the bracket and the power unit before positioning it on the column.
•
Apply screws and washers
screws), the bracket is designed to be easily hung through the head of the screws to
facilitate placement of the power unit.
•
Mount the electro-hydraulic power pack in the upper part of the control column.
•
Also insert and tighten the lower screws

WARNING
The manufacturer declines liability for any damages
resulting from failure to follow the above
instructions, which may invalidate the warranty.
and washers by inserting the anti-vibration washers between
for 5 mm on the column (only the two upper
3
Operator's manual [EN]