Cameo OPUS W5 Manuel D'utilisation page 17

STANDALONE STATIC MODE (Master and Alone)
The Static mode allows PAN, Tilt, Dimmer, Strobe, Colour Wheel and Gobo Wheel etc. to be
adjusted directly on the device with values between 000 to 255, similar to a DMX control unit.
In this way, an individual scene can be created without an additional DMX controller. Here you
can choose between the "Master" mode (with output of the control signal to slave devices) and
"Alone" (no influence on the DMX signal). After selecting the "Master" or "Alone" mode as de-
scribed above under "STANDALONE MODES", the settings can be made as desired. The informa-
tion on the submenu items in the static menu and the relevant setting options are shown in the
table below (selection with
with ENTER).
Stand Alone
Master
512
Alone
Auto Prog
Slave
and , confirm with ENTER, change value with
Stand Alone Mode Master / Alone
Function
Pan 000 - 255 0% to 100%
Pan fine 000 - 255 0% to 100%
Tilt 000 - 255 0% to 100%
Tilt fine 000 - 255 0% to 100%
Dimmer 000 - 255 0% to 100%
000 - 005 Strobe open
006 - 010 Strobe closed
011 - 022 Ramp up/down, slow -> fast
023 - 033 Ramp up/down random, slow->fast
034 - 045 Ramp up, slow -> fast
046 - 056 Ramp up random, slow -> fast
Strobe
057 - 068 Ramp down, slow -> fast
functions
069 - 079 Ramp down random, slow -> fast
080 - 102 Random Strobe effect, slow -> fast
103 - 127
128 - 250 Strobe slow -> fast <1Hz - 20Hz
251 - 255 Strobe open
Cyan 000 - 255 0% to 100%
Values
Strobe Break effect, 5s.....1s (short burst
with break)
and , confirm
17