Publicité
Les langues disponibles
Les langues disponibles
Registering additional door monitors
The receiver and monitor are already registered together when pur-
chased as a set. The following instructions are for the registration of up to
3 additional monitors:
1. Press any key to switch the display on. Press the menu key
enter the main menu. With the navigation keys, select "Register"
and press the menu key
dure.
2. Door monitor:
Take the battery casing off. Press the call button and use a pointed
object (e.g. needle or bent paper clip) to press and hold the
register key.
See the figure below for the location of the register key.
register key
3. When a single prompt tone is heard, you can release the register
button. The registration of the monitor has been successful.
If a double prompt tone is heard, the registration has failed.
In this case, turn the receiver off. Disconnect the according door
monitor from its power source (take batteries out / disconnect from
power supply) for 30 seconds. Reconnect the power source.
Switch the receiver on and repeat the previous steps.
Make sure that monitor and receiver are not too far apart.
4. A maximum of 4 monitors can be registered. If an attempt is made
to register more than 4 door monitors, the register interface will
display "Register full".
once more to start the search proce-
to
EN
English 25
Publicité
