Power supply and product installation
• DO NOT WATCH VIDEO WHILE DRIVING. Watching the video may distract the
driver from looking ahead of the vehicle and cause an accident.
• DO NOT DISASSEMBLE OR ALTER. Doing so may result in an accident, fire or
electric shock.
• USE ONLY IN CARS WITH A 12 VOLT NEGATIVE GROUND. (Check with your
dealer if you are not sure.) Failure to do so may result in fire, etc.
• USE THE CORRECT AMPERE RATING WHEN REPLACING FUSES. Failure to do so
may result in fire or electric shock.
• DO NOT BLOCK VENTS OR RADIATOR PANELS. Doing so may cause heat to
build up inside and may result in fire.
• USE THIS PRODUCT FOR MOBILE 12V APPLICATIONS. Use for other than its
designed application may result in fire, electric shock or other injury.
• MAKE THE CORRECT CONNECTIONS. Failure to make the proper connections
may result in fire, battery drain, or product damage.
• BEFORE WIRING, DISCONNECT THE CABLE FROM THE NEGATIVE BATTERY
TERMINAL. Failure to do so may result in electric shock or injury due to electrical
shorts.
• DO NOT ALLOW CABLES TO BECOME ENTANGLED IN SURROUNDING
OBJECTS. Arrange wiring and cables in compliance with the manual to prevent
obstructions when driving. Cables or wiring that obstruct or hang up on places
such as the steering wheel, gear lever, brake pedals, etc. can be extremely
hazardous.
• DO NOT SPLICE INTO ELECTRICAL CABLES. Never cut away cable insulation to
supply power to other equipment. Doing so will exceed the current carrying
capacity of the wire and result in fire or electric shock.
• DO NOT DAMAGE PIPE OR WIRING WHEN DRILLING HOLES. When drilling
holes in the chassis for installation, take precautions so as not to contact, damage
or obstruct pipes, fuel lines, tanks or electrical wiring. Failure to take such
precautions may result in fire.
• DO NOT USE BOLTS OR NUTS IN THE BRAKE OR STEERING SYSTEMS TO MAKE
GROUND CONNECTIONS. Bolts or nuts used for the brake or steering systems
(or any other safety-related system), or tanks should NEVER be used for
installations or ground connections. Using such parts could disable control of the
vehicle and cause fire etc.
• DO NOT INSTALL IN LOCATIONS WHICH MIGHT HINDER VEHICLE
OPERATION, SUCH AS THE STEERING WHEEL OR SHIFT LEVER. Doing so may
obstruct forward vision or hamper movement etc. and results in serious accident.
• DO NOT OPERATE ANY FUNCTION THAT TAKES YOUR ATTENTION AWAY
FROM SAFELY DRIVING YOUR VEHICLE. Any function that requires your
prolonged attention should only be performed after coming to a complete stop.
Always stop the vehicle in a safe location before performing these functions.
Failure to do so may result in an accident.
5