Replacing Light Bulbs - Amana ASD2622HRB Guide D'utilisation Et D'entretien

Care and Cleaning

Replacing Light Bulbs

WARNING
To avoid electrical shock which can cause severe
personal injury or death, disconnect power to
refrigerator before replacing light bulb. After
replacing light bulb, reconnect power.
CAUTION
To avoid personal injury or property damage,
observe the following:
• Allow light bulb to cool.
• Wear gloves when replacing light bulb.
Upper Fresh Food Section
The upper fresh food light bulbs are located behind the
front panel. Reach behind the panel to remove the
bulbs.
Lower Fresh Food Section
1. Push up on bottom tabs on light
cover. Rotate cover up and release
tabs.
2. Remove light bulb.
3. Replace bulb with appliance bulb
no greater than 40 watts.
4. Insert top tabs of light cover into
liner slots and snap bottom tabs
into liner slots.
Upper Freezer Section
1. Remove ice bin by lifting
front of bin and pulling
out.
2. Remove light shield by
pressing the upper right side of the shield and
rotating downward.
3. Remove light bulb. Replace with appliance bulb no
greater than 40 watts.
4. Rotate the shield upward press in slightly and snap
into place.
5. Replace ice bin by sliding in until bin locks into
place.
Lower Freezer Section
1. Pinch both sides of light cover to remove.
2. Remove light bulb. Replace with appliance bulb no
greater than 40 watts.
3. Pinch both sides of the light cover to snap into
place.
Ice and Water Dispenser
Light Bulb
Location
1. Locate light bulb inside top edge of dispenser
frame. Unscrew to remove.
2. Replace light bulb with a 7-watt, 120 volt bulb.
26