Wiring Loewe Flat Tv - Auro - Individual Sound (L2650) - Loewe Audio Individual Sound Mode D'emploi

Connection
Wiring Loewe Flat TV – Auro – Individual Sound (L2650)
Loewe Flat-TV
Digital audio TV -> Auro
Loewe
Only necessary for TV as
Auro
a center loudspeaker
Connect the cables as shown in the graphic:
• Connect Auro to socket AV2 of the Loewe Flat TV. You must use a Euro-AV
cable in which all contacts are wired.
• To get a better picture quality, use a three-wire cinch cable (available from
your dealer) and connect it to Auro "COMPONENT VIDEO OUT" and "SD/HD-
COMPONENT IN" of the TV set. Set the "VIDEO OUT SELECTOR" switch on the
back of Auro to the "COMP." position.
• With a six-wire cinch cable (available from your dealer), connect the cinch
socket group "PRE-OUT" of Auro to the cinch socket group "Line-IN" k of the
subwoofer. Connect the sockets as follows:
- Auro socket "Preout C" to subwoofer socket "Line IN Center";
- Auro socket "Preout LFE" to subwoofer socket "Line IN Subw.";
- Auro socket "Preout L" to subwoofer socket "Line IN Front Left";
- Auro socket "Preout R" to subwoofer socket "Line IN Front Right";
- Auro socket "Preout SL" to subwoofer socket "Line IN Surr. Left";
- Auro socket "Preout SR" to subwoofer socket "Line IN Surr. Right".
AV2-SCART
CENTER
COMPONENT IN
PREOUT AUX1 IN AUX OUT AUX 2
L C R L L
DIGITAL
IN
DIGITAL
OUT
SL LFE SR R R
12V / 15mA
Six-pole cinch
Audio cable cinch -> SCART
(available in specialised
trade)
AUDIO OUT L/R
DIGITAL OUT
SERVICE
Component Video
(available in specialised
trade)
EURO-AV-cable
Y
TO TV
Pb
TV EXT Pr
COMPONENT
L-LINK VIDEO OUT
L-Link-cable
Cubic plug cable
• Connect the cubic plug cable from the "System connector" socket e on the
subwoofer to the cubic socket on Auro (the side of the cable with anti-kink).
The cubic plugs are secured in the socket by a lug.
You have to press down the lug À rst before you can remove the cubic plug.
• To use the TV as a center loudspeaker connect "AUDIO IN C" on the TV set to
"PRE OUT C" on the DVD Preceiver with a cinch cable (the connection of the
center cable "C" between Auro and Individual Sound is omitted).
• To play the TV sound over Auro/Individual Sound, connect the digital audio
output of the TV set "AUDIO DIGITAL OUT" with the "DIGITAL IN" input from
Auro with a cinch cable.
• Before establishing the L-Link, Auro and the TV must be in the powerless
state otherwise these devices cannot identify each other after switching on.
• Audio cable cinch -> SCART (available from your dealer) when using the
component signal and "TV as center speaker".
Loewe Individual Sound System
ON
Power OUT
R
Surr.
OFF
L
R
Bass Intensity
Front C
Min. Max.
L
Phase
0 180
Line IN
Crossover Frequency
Right Subw. Left
Surr.
50 250.
Front
Right Center Left
230V~50/60Hz
System connector
19 -