Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Imprint
Version V01 / 2019-03
Copyright:
Maschinenfabrik
OTTO BAIER GmbH
Heckenwiesen 26
71679 Asperg
Germany
It is prohibited to forward or reproduce this
document or to exploit and disclose its contents,
unless expressly permitted. Any infringements will
result in liability to pay compensation for damages.
All rights reserved in case of patent, utility model or
design registration.
This instruction manual has been prepared with
the greatest possible care. Nonetheless, OTTO
BAIER GmbH does not accept any liability
whatsoever for possible errors in this instruction
manual and their consequences. Equally, no liability
whatsoever is accepted for direct or consequential
damage or losses resulting from improper use of the
machine.
The national health and safety regulations and the
requirements of this instruction manual are to be
observed when using the machine.
All product names and brand names used are the
property of the holder and are not explicitly marked
as such.
Subject to change without notice.
Contents
1
About this instruction manual ........... 18
1.1
Important information ............................. 18
1.2
2
Safety Instructions .............................. 19
2.1
Operating personnel requirements ........ 19
2.2
Workplace safety .................................... 19
2.3
Electrical safety ...................................... 19
2.4
Safety of people ...................................... 19
2.5
Using and handling the drill stand .......... 19
2.5.1
Service / Maintenance / Repair .............. 21
2.5.2
drill stand ................................................ 21
3
Technical Characteristics ................... 22
3.1
3.2
EC Declaration of Conformity ................ 22
3.3
Controls .................................................. 22
3.4
Intended use ........................................... 23
4
Before starting work ............................ 23
5
Operation and Control ......................... 23
5.1
5.2
Fixing onto the wall ................................. 23
5.3
kit (accessory) ........................................ 23
5.4
Adjusting the tilt at the drill stand ........... 24
5.5
the BST 200 drill stand ........................... 24
5.6
the BST 250 drill stand ........................... 24
5.7
Work instructions .................................... 24
6
Cleaning ................................................. 25
7
Maintenance .......................................... 25
7.1
spindle head ........................................... 25
8
Tools and Accessories ........................ 26
9
Disposal ................................................. 26
10
Scope of Supply ................................... 26
11
Warranty ................................................ 27
| 17 |
Publicité
Chapitres
Table des Matières
