Silverline 783100 Mode D'emploi page 7

783100
2. Remove the Collet (1) from the shaft and insert the collet size you require
3. Replace the collet nut
Installing an accessory
WARNING: Always disconnect the tool from the air supply before changing collets
or installing/removing accessories.
1. Check the appropriate size collet is fitted; fit correct size if necessary (see
'Changing the collet')
2. Insert the mandrel of the accessory as far into the collet as it will go
3. Tighten the Collet Nut (6) by hand, then fit the two supplied Spanners (7): the
larger one on the collet nut, the smaller on the drive shaft
4. Tighten the collet so that the accessory is securely fixed in place. Pull on the
end of the accessory to check
Operation
Note: DO NOT allow the tool to run in 'idle rotation' for an extended period of time.
This will shorten its life.
1. Hold the tool firmly in the palm of your hand
2. Disengage the Safety Catch (2) and press the Trigger (3) to operate the tool
3. Allow the tool to reach full speed before bringing the accessory into contact
with the workpiece
4. Release the trigger to stop the tool
WARNING: Be aware that air tools may hold residual pressure after use. Always
bleed air pressure from the tool after shutting off air supply.
Accessories
• Accessories for this tool, including grinding stones, wheels, rotary rasps, etc. are
available from your Silverline stockist. Spare parts can be obtained from your
Silverline dealer or www.toolsparesonline.com
Maintenance
WARNING: Always disconnect from the air supply and depressurise before
cleaning or carrying out any maintenance.
Cleaning
• Keep your tool clean at all times. Dirt and dust will cause internal parts to wear
quickly, and shorten the machine's service life. Clean the body of your machine
with a soft brush, or dry cloth
IMPORTANT: There is very little that can go wrong with your air tool and it should
be noted that when an air tool fails to work it is generally because the internal
workings have corroded due to dirty, wet air and failure to follow the instructions
given below.
Daily maintenance procedure: Disconnect from the air supply, pour the equivalent
of a tablespoon of oil into the air intake. Operate the machine at low speed to
thoroughly lubricate all internal workings.
• If the machine is in constant use or used for long periods at a time, a combined
filter/lubricator must be fitted. There must be an air filter fitted at all times
• Use air tool oil. DO NOT UNDER ANY CIRCUMSTANCES USE NORMAL ENGINE OIL
• Failure to comply with the operating and maintenance instructions may
invalidate the guarantee
15pce Air Die Grinder Kit
Storage
• Store this tool carefully in a secure, dry place out of the reach of children
Disposal
• As with other power tools, air tools should not be disposed of with household
waste
• Air tools may contain traces of tool oil and other lubricants and so must be
recycled accordingly
• Contact your local waste disposal authority for information on the correct way
to dispose of power tools
www.silverlinetools.com
7