Honda 08L14-TF0-600W Notice De Montage Et D'utilisation page 17

Note!
When operation with the bicycle rack, a left and right outside mirror are required.
The maximum capacity of the bicycle rack of 30 kg may not be exceeded. The bicycle rack is approved only for transporting bicycles (up to 2
bicycles).
The maximum permissible axle load and the permissible total weight of the vehicle (see vehicle operating manual) must also be observed with bicycle
racks and bicycles.
If the load protrudes more than 40 cm outside the outer rim of the light beam surface of the limit or rear lights of the bicycle rack, it has to be identified
on the side at no more than 40 cm from its edge and no more than 150 cm above the road surface, to the front with a white and to the rear with a red
light.
Speed limits and other traffic regulations of the corresponding country have to be obeyed. Maximum speed is 130 km/h.
The installed bicycle rack may affect the driving properties for curves and while braking.
The speed needs to be adjusted to the payload and other conditions.
The vehicle length is increased by the installed bicycle rack; while loaded, width and height may change as well. Caution in reverse, at entrances and
exits, and when entering parking garages.
The vehicle operator is responsible so that his view and hearing are not impaired by the load or the condition of the vehicle. He has to ensure that the
vehicle and the load meet specifications and that the traffic safety of the vehicle is not affected.
The obligatory light and lighting systems have to be available and operational during daytime as well.
While driving, the light wings always have to be folded out.
Only the manufacturer is authorised to repair and dismantle the closing and locking mechanism.
Precautions!
Before driving, check proper function of the rear lights and of the license plate lights. When the rear fog light on the bicycle rack is switched on, the
vehicle rear fog light has to be off, i.e. they should not be on at the same time.
Before transport, remove all loose parts on the bicycles.
Also remove child seats, shopping baskets, pumps and batteries from electro bicycles. They may come loose during transport and constitute a danger
for other drivers.
Trips without a loaded bicycle rack ought to be avoided, for example to conserve energy and the obligation to reduce risk of damages.
Do not cover the bicycles with plastic sheets or other protective covers.
Heavy loads in the trunk should be stored as far to the front as possible in order to ensure an even rear weight distribution.
If the vehicle is equipped with an electric tailgate, please ensure the necessary free space once the bicycle rack is installed. If possible, it should be
deactivated and manually operated.
For vehicles with an electronic acoustic parking system, malfunctions may appear once the bicycle rack is installed.
Damaged and worn parts of the bicycle rack should be replaced immediately. While driving, all screws and levers of the installed bicycle rack should
be tightened. It is recommended to always lock the handwheels.
While driving, the bicycle rack must always be locked.
Modifications to the bicycle rack are generally not permitted. Repairs or replacement of parts should be carried out by a specialised company only.
Only original spare parts may be used.
For vehicle types whose initial permit was issued after October 01, 1998, the installed bicycle rack or the load may not cover the third brake light of the
vehicle. The third brake light of the vehicle has to be visible: right and left in relation to the vehicle's longitudinal axle – in a horizontal angle of 10°, to the
top in relation to the light edge – in a vertical angle of 10° and to the bottom – in relation to the light bottom edge – in a vertical angle of 5°. If these
values are not obeyed, a third replacement brake light has to be installed.
The bicycle rack is suited for the transport of bicycles with standard frames.
HONDA assumes no liability for personal and/or property damage or damage caused thereby due to improper assembly or use of the product.
While driving at night, the reflectors of the wheels should be covered so that other road users are not deceived or irritated.
The light is intended for a 12 V system.
The license plate on the bicycle rack has to conform to the license plate of the vehicle.
The license plate and the lighting system of the bicycle rack may not be covered.
While driving, the driver should check the rearview mirror in order to assure proper attachment of the bicycle rack and detect possible shifting as
quickly as possible.
In case of changes with reduced speed, continue driving until it is safe to stop and retighten screws and fasteners of the bicycle rack or the cargo.
Check the cargo during every travel stop and retighten the fasteners if necessary.
Carrying the bicycle rack may influence the air flow behind the vehicle, which may possible disturb the cleaning of the rear window for example.
These installation and operating instructions include the general permit for the bicycle rack, which always has to be taken along in the vehicle.
Maintenance instructions!
The bicycle rack can be cleaned with water and normal car shampoo. Please do not use a high-pressure jet.
Please disassemble the bicycle rack before using a car wash.
Locks: After 100 locking cycles, after 2 months at the latest, the locks need to be serviced. Spray the dust cover and the inside of the cylinder with
resin-free oil and activate a couple of times with the key.
Subject to change.
08L14-TF0-600W
17