Build Worker BBBS350-8 Notice D'utilisation page 17

INSTRUCTIONS FOR USE
Set the saw band protection to leave just enough
space for the workpiece to be fed along the saw
band.
Switch on the machine before the workpiece
makes contact with the saw band.
Hold the workpiece with both hands and slowly
feed it along the saw band.
Do not exert pressure on the saw band. Allow the
machine enough time to cut the workpiece.
Best results are achieved with workpieces up to
approx. 2.5 cm.
Workpieces thicker than approx. 2.5 cm should
be fed along the saw band very slowly. Be extra
careful not to bend the saw band.
To maintain optimum efficiency, replace a worn
saw band in time.
SWITCHING ON AND OFF
This machine is equipped with a no-volt release
feature.
This feature avoids that the machine is accidentally
switched on when the plug is inserted into the mains
outlet.
To switch the machine on, set the on/off switch
(1) to 'I'.
To switch the machine off, set the on/off switch
(1) to '0'.
LUBRICATION
Regularly apply a drop of oil to lubricate the
guide rollers on the saw band guides.
CLEANING AND MAINTENANCE
The machine does not require any special
maintenance.
Regularly clean the ventilation slots.
Regularly remove sawdust from the housing and
the wheel case.
TECHNICAL DATA
Mains voltage V
Mains frequency
No load speed min-1
Max. depth of cut mm
Saw band length mm
Table dimensions mm
Weight kg
LpA (sound pressure) dB(A)
GUARANTEE
Refer to the enclosed guarantee conditions for the
terms and conditions of guarantee.
ENVIRONMENT
Should your machine need replacement
after extended use, do not put it in the
domestic waste but dispose of it in an
environmentally safe way.
230
350
1,450
80
1425
300 x 300
17
< 80.5
17