Pentair FP0S3000X Notice D'utilisation page 2

Safety
Important Safety Instructions
SAVE THESE INSTRUCTIONS - This manual contains
important instructions that should be followed during
installation, operation, and maintenance of the product.
This is the safety alert symbol. When you see this
symbol on your pump or in this manual, look for one of
the following signal words and be alert to the potential for
personal injury!
indicates a hazard which, if not avoided, will
result in death or serious injury.
indicates a hazard which, if not avoided, could
result in death or serious injury.
indicates a hazard which, if not avoided, could
result in minor or moderate injury.
NOTICE addresses practices not related to
personal injury.
Carefully read and follow all safety instructions in this
manual and on pump.
Keep safety labels in good condition. Replace missing or
damaged safety labels.
California Proposition 65 Warning
This product and related accessories contain
chemicals known to the State of California to cause
cancer, birth defects or other reproductive harm.
General Safety
Risk of electric shock. Can shock, burn or
kill. To reduce the risk of electric shock, use only on
portable self-contained fountains no larger than 5 feet in
any dimension.
1. Pump is designed for use with clean, cold, fresh
water. Do not use to pump any flammable liquid.
2. Do not lift pump by power cord at any time.
Attempting to lift or support the pump by the power
cord can damage the cord and cord connections, and
will void warranty. Always lift the pump by the lifting
handle.
3. Meet National Electri cal Code, Canadian Elec tri cal
Code, and local codes for all wiring. The National
Electric Code requires installation of a ground
fault circuit interrupter (GFCI) in the branch circuit
supplying fountain pumps and other pond equipment.
Purchase a GFI at your local electrical supply dealer.
4. Installation must comply with all local codes
pertaining to outdoor ponds/waterfall/fountains.
5. Know the pump application, limitations, and potential
hazards.
6. Disconnect the power before servicing.
7. Release all pressure within the system before
servicing any component.
8. Drain all water from the system before servicing.
9. Secure the discharge line before starting pump. An
unsecured discharge line will whip, possibly causing
personal injury and/or property damage.
10. Check hoses for weak or worn condition before each
use, making certain that all connections are secure.
11. Periodically inspect the pump and system
components. Keep the screen free of debris and
foreign objects. Perform routine maintenance
as required.
12. Personal Safety:
a. Wear safety glasses at all times when working
with pumps.
b. Keep work area clean, uncluttered and properly
lighted – replace all unused tools and equipment.
c. Keep visitors at a safe distance from work area.
d. Make workshop child-proof – with padlocks,
master switches, and by removing starter keys.
13. This equipment is only for use on 115 volt (single
phase) and is equipped with an approved
3-conductor cord and 3-prong, grounding-type
plug.
Risk of electric shock. Can shock,
burn or kill. To reduce risk of electric shock, pull
plug before servicing. This pump has not been
investigated for use in swimming pool areas. Pump is
supplied with a grounding conductor and grounding-
type attachment plug. Be sure it is connected only to
an individual branch circuit with a properly grounded
grounding-type receptacle.
Where a 2-prong wall receptacle is encountered, it
must be replaced with a properly grounded 3-prong
receptacle installed in accordance with codes and
ordinances that apply.
14. Make certain power source conforms to
requirements of your equipment.
15. Protect the electrical cord from sharp objects,
hot surfaces, oil, and chemicals. Avoid kinking
cord. Replace or repair damaged or worn
cords immediately.
16. Do not touch an operating motor. Modern motors are
designed to operate at high temperatures.
17. Do not handle pump or pump motor with wet hands
or when standing on wet or damp surface, or
in water.
2