Bonnet Neve DUO MODULAR Instructions Pour L'utilisateur page 17

DEFROSTING
The number and duration of defrosts are factory-set. The user must never alter their adjustment.
Defrost-water is collected by a drain tube and conveyed into a drainage system. Periodically check that defrost water
flows off normally. Otherwise, unclog by the use of a pointless flexible probe.
9. PRESCRIPTIONS AND RESTRICTIONS
KEEPING PHARMACEUTICAL PRODUCTS, GLASS BOTTLES OR FLASKS IN THE SHOWCASE IS STRICTLY
FORBIDDEN as they could get broken and entail a safety hazard (fig. 13).
Except for the condenser guard, which needs to be removed in order to clean the condenser, DO NOT
REMOVE COVERS OR PANELS WHEN IT REQUIRES THE USE OF TOOLS AND ESPECIALLY DO NOT REMO-
VE THE ELECTRIC CONTROL BOARD COVER.
Do not expose the showcase to atmospheric agents.
Do not spill water directly or indirectly on the showcase (fig. 17). Do not touch the machine with damp or
wet hands or feet; do not use it while barefoot (fig. 16).
ATTENTION: The refrigerating system does not alter defrost water in any way, which is the product of the
steam contained in the air circulating inside the showcase. Defrost water and wash water may nonetheless
mix with pollutants deriving from the products preserved in the appliance, from preservation means, from
product remains, from the accidental crush of recipients containing liquids or from the use of improper deter-
gents (see section 10 point 1).
THE WATER PRODUCED BY THE SYSTEM MUST THEREFORE BE DISPOSED OF THROUGH A SEWER OR
PURIFICATION SYSTEM IN COMPLIANCE WITH THE REGULATIONS IN FORCE.
DO NOT LEAN ON FRONT GLASS OF CABINET NOR REST ANY OBJECT OF ANY WEIGHT AGAIN-
ST IT (EVEN BRIEFLY)
ANY OTHER USE NOT EXPLICITLY MENTIONED IN THIS BOOKLET MUST BE CONSIDERED AS HAZARDOUS.
THE MANUFACTURER DISCLAIMS ALL LIABILITY FOR ANY DAMAGE RESULTING FROM IMPROPER, INCOR-
RECT OR UNREASONABLE USE.
10. ORDINARY MAINTENANCE
ATTENTION! BEFORE MAINTENANCE OR CLEANING, DISCONNECT THE REFRIGERATOR FROM THE ELEC-
TRICAL POWER SUPPLY USING THE WALL MAIN CUTOFF SWITCH (fig. 19).
IMPORTANT: During maintenance or cleaning operations, be sure that the light in the working area is suffi-
cient. If necessary, use an additional source of light. Mind also the hot and moving parts marked with the
relevant symbol. The use of heavy-duty gloves is recommended.
CLEANING THE CABINET
1) Every week clean the outer surfaces of the showcase with mild soap or detergent in lukewarm water only.
Wipe carefully with a soft cloth. Never clean it using inflammable or scouring agents, alcohol, acetone or solvents.
NEVER CLEAN THE DISPLAY CASE BY THE USE OF WATER JETS (fig. 17). Clean glass surfaces using glass-
cleaning products only. The use of water is not recommended here, as it may cause scale to build up.
17