Publicité
Les langues disponibles
Les langues disponibles
G
Measuring transducers, calibrateable, with active output
TEMPERATURE RANGES: When selecting measuring transducer ranges,
it is necessary to ensure that the maximum temperatures permissible for sensor ⁄ housing are not exceeded !
Ambient temperature for measuring transducers: – 30 ...+ 70 °C, Apparent ohmic resistance = see load resistance diagram
Load resistance diagram
800
700
600
500
400
300
250
200
50
10
15
Operating voltage (V DC)
SUPPLY VOLTAGE :
For operating voltage reverse polarity protection, a one-way rectifier or
reverse polarity protection diode is integrated in this device variant.
This internal one-way rectifier also allows operating 0 - 10 V devices on AC
supply voltage.
The output signal is to be tapped by a measuring instrument. Output
voltage is measured her against zero potential (O V) of the input voltage!
When this device is operated on DC supply voltage , the operating voltage
input UB+ is to be used for 15...36 V DC supply and UB – or GND for
ground wire!
When several devices are supplied by one 24 V AC voltage supply, it is to
be ensured that all "positive" operating voltage input terminals (+) of the
field devices are connected with each other and all "negative" operating
voltage input terminals (–) (= reference potential) are connected together
(in-phase connection of field devices). All outputs of field devices must be
referenced to the same potential!
In case of reversed polarity at one field device, a supply voltage short-
circuit would be caused by that device. The consequential short-circuit
current flowing through this field device may cause damage to it.
Therefore, pay attention to correct wiring!
®
THERMASGARD
ALTM 1
Type ⁄ WG01
Sensor
A LT M1- I
Pt1000
A LT M1- I LCD
Pt1000
A LT M1- U
Pt1000
A LT M1- U LCD
Pt1000
Extra charge:
Other ranges optional
Cable connection with M12 connector according to DIN EN 61076-2-101
Load resistance diagram
4...20 mA
Admissible
range
20
25
30
35 36 40
Surface contact ⁄ tube contact temperature measuring transducers (compact)
Output
4...20 mA
4...20 mA
0 -10 V
0 -10 V
Dependency of output voltage on output current
12
Ua (V)
10
8
6
4
2
0
0
0,5
Connecting scheme
Power supply
AC 24V~
0V
DC 15-36V = GND
Connecting scheme
Power supply
AC 24V~
0V
DC 15-36V = GND
Type
Compact
Compact
Compact
Compact
Ia (mA)
1,0
1,5
2,0
2,5
3,0
3,5
Individual operation
Circuitry
V
Parallel operation
Circuitry
Circuitry
Display
Item No.
1101- 1112- 0219-920
■
1101-1112- 2219- 920
1101-1111- 0219- 920
■
1101-1111- 2219- 920
on request
4,0
4,5
Publicité
