BDR Thermea Group SCB-01 Notice D'utilisation Et D'installation page 8

en
4 Settings
Tab.4 Factory settings at installer level
Code Display text
EP018 Status relay func.
EP019 Status relay func.
EP028 Function 10V-PWM
EP029 Source 10V-PWM
Tab.5 Navigation for advanced installer level
Display Level
Advanced installer
Advanced installer
(1) See the column "Submenu" in the following table for the correct navigation. The parameters are grouped in specific functionalities.
Tab.6 Factory settings at advanced installer level
Code Display text
AP077 Max. display level
8
Description
Status relay function
Status relay function
Selects the function of the 0-10 Volt output 0 = 0-10V 1 (Wilo)
Selects the source signal for the 0-10 Volt
output
Menu path
> SCB-01 > ADV
> Installation Setup > SCB-01 > Submenu
Parameters
Description
Maximum Level of parameters and signals
to display on MK
Range
0 = No Action
1 = Alarm
2 = Alarm Inverted
3 = Burning
4 = Not burning
5 = Reserved
6 = Reserved
7 = Service request
8 = Boiler on CH
9 = Boiler on DHW
10 = CH pump on
11 = Locking or Blocking
12 = Cooling mode
0 = No Action
1 = Alarm
2 = Alarm Inverted
3 = Burning
4 = Not burning
5 = Reserved
6 = Reserved
7 = Service request
8 = Boiler on CH
9 = Boiler on DHW
10 = CH pump on
11 = Locking or Blocking
12 = Cooling mode
1 = 0-10V 2 (Gr. GENI)
2 = PWM signal (Solar)
3 = 0-10V 1 limited
4 = 0-10V 2 limited
5 = PWM signal limited
6 = PWM signal (UPMXL)
0 = PWM
1 = Requested power
2 = Actual power
> Parameters, counters, signals > Adv.
(1)
Range
0 = System
1 = End user
2 = Installer
3 = Installer advanced
4 = Lab
5 = Controls Development
Subme­
nu
Status
informati
on
Status
informati
on
0-10 volt
or PWM
out
0-10 volt
or PWM
out
Subme­
nu
System
Function
ality
7741254 - v.01 - 22112019