LVI Touch E3 Manuel D'installation Et D'utilisation page 83

• If you want to edit device information/settings, press the button with a Red dot
(long Press):
- Device name,
- Power,
- Set front panel max surface temperature level.
> Press "Heating rate maximum level" rate.
> Select P1, P2 or P3. NOTE: the first paired radiator must have the same
or higher value than the rest of the radiators in the room, otherwise the energy
calculation will be wrong.
> Press "Green check"button to confirm.
- For double radiator, change to sequential control.
> Press "Sequential control"button
> Select "No"(default setting) if the radiator's front and back panel should be
evenly heated.
> Select "Yes"if the radiator's front and back panel should be heated sequentially.
> Press "Green check"button to confirm.
08. Screen lock
• Press "Screen lock" button
• Enter your personalized code (it must contain 4 characters)
• Press "Green check" button to confirm
Note: the default code is 1066
09. Heating settings
Set Minimum and Maximum allowed temperatures in each room.
• Press "Heating Settings" button
• Press a room button
10. WiFi settings (See "WiFi settings" section, p 84)
11. General factory default (all updates and user data will be erased except WiFi-
settings. They are reset under WiFi settings (See "WiFi settings" section, p 84)
by pressing the the Red "Reset" button (long press)
• Press "Green check"button to confirm
• Press "Red cross"to decline
12. Update firmware
• Insert SD card with new firmware
• Press "Update firmware"
• Press "Green check"button to confirm
• Press "Red cross"to decline
Please wait until the end of the update procedure before removing the microSD from the Central
Unit.The end of the procedure is denoted by the appearance of the wi-fi button on the Central Unit
FOR THE INSTALLER AND FOR
ADVANCED USERS
P16MI417 - A01 - 11/15
UK
83 |