LVI Touch E3 Manuel D'installation Et D'utilisation page 68

FOR
UK
THE INSTALLER
• Screw the power supply on to the wall.
NOTE: The tab must be located at the top.
• Put the switch into the ON position by using a small pin
ON / OFF
• Mount the Touch E3 on the power supply and slide it down until it stops.
• The Touch E3 is now ready for use.
04. Table installation
CABLE
ON / OFF
• Connect the mini USB cable and charger to the Touch E3.
• Mount the Touch E3 onto the bracket by sliding it down until it stops.
• Put the switch into the ON position by using a small pin
• The Touch E3 is now ready for use.
| 68
P16MI417 - A01 - 11/15
60 MM