LVI Touch E3 Manuel D'installation Et D'utilisation page 71

• Press "Green check" button to confirm
• Device (Radiator or Remote Control) to measure the temperature
must be paired first in this zone!
• Press "Green check" button to confirm
03. Put the device (radiator or remote control) in pairing mode.
• See device leaflet or manual
EXAMPLE: YALI DIGITAL /P/R
Press and hold the "OK" key for 5 seconds
rFi: Wireless Radio initialization (pairing)
Press "OK" to enter this initialization sequence.
Select with "+"or "-" the radio communication type and validate by pressing "OK":
• rF.un: unidirectional communication, the digital thermostat only receives
orders from an LVI RF central programmer.
• rF.bi: bidirectional communication with an LVI Touch E3. The digital
thermostat communicates state and power consumptions to the LVI Touch E3.
Then the backlight will switch off and the digits will cycle showing that
the digital thermostat is waiting for a radio link signal from a Central
programmer or LVI Touch E3 to be received (press ""to cancel radio
initialization). When the radio link signal is received, pairing is saved,
then it will return to Auto mode.
• Start the pairing by pressing "radio pairing" button
• Follow the instruction on the screen (depending on the type of device) .
• Repeat the steps for all devices, starting at >> Select radio pairing
THE INSTALLER
f
RADIO PAIRING
BUTTON
f
P16MI417 - A01 - 11/15
FOR
UK
71 |