Installation Of The Wine Cabinet - BORETTI BPWKN 177 Manuel D'instructions

Installation of the wine cabinet

Note
Before connecting the wine cabinet to the power source, let
it stand upright for approximately 2 hours. This will reduce
the possibility of a malfunction in the cooling system from
handling during transportation.
* Remove the exterior and interior packing.
* Clean the interior surface with lukewarm water using a soft cloth.
* Install the handle on the left side of the door.
* Place the wine cabinet on a floor that is strong enough to support it
when it is fully loaded.
* Locate the wine cabinet away from direct sunlight and sources
of heat (stove, heater, radiator, etc.). Direct sunlight may affect
the acrylic coating and heat sources may increase electrical
consumption. Extreme cold ambient temperatures may also cause
the unit not to perform properly.
* Avoid locating the unit in moist areas.
* The wine cabinet should be positioned where the ambient
temperature is between 5°C and 35°C. If the ambient temperature
is above or below this range, the performance of the unit may be
affected. Placing the appliance in extreme cold or hot conditions
may cause the interior temperatures to fluctuate. The range of
setting temperatures may not be reached.
* Put the plug of the wine cabinet into an appropriate socket. Should
the plug require changing, get help from a qualified service technician.
Reversing the door swing of the wine cabinet
This appliance has the capability of the door opening from either the left
or right side. The unit is delivered to you with the door opening from the
left side. Should you desire to reverse the opening direction, please call
service for reversal instructions.
34