Inflating With The Pump Hose (Flexible Low Pressure Hose) - AEG MV 10 Notice D'utilisation

Attention! Excessive air pressure may
cause the item to burst! Risk of personal
injury and property damage!
▪ Once the air pressure marking on the adjusting
ring has been reached the compressor will
5
automatically switch off.
▪ To completely switch the unit off, simply set the
compressor switch to ( O ) and disconnect the
unit from the power supply. Automatic restart
warning! If the compressor On / Off switch
is set to ( I ) when reconnecting the unit to power
the compressor will automatically start and
compressed air will be blown through the air
hose and the inflating valve, and air sucked in
through the suction valve. Risk of personal
injury and property damage!
▪ Remove the valve adapter from the product's
valve and close the product's valve cap.
4.4 Inflating with the pump hose
(flexible low pressure hose)
16
Low pressure
hose
Image 8
The included flexible low pressure hose is
particularly suited to inflate items with a high
volume (e.g. air mattresses or inflatable boats) as
it can be attached to the inflating valve
inflate the object and the suction valve
deflate the item (see Image 8).
15
Valve adapter
to
15
to
16
The approx. 18.0 mm valve connector and the
two valve adapters approx. 10.0 mm and 7.0
mm in diameter make the hose suitable for
product valves with various diameters.
Do not operate the compressor longer
than 10 minutes, then allow the unit to
cool down for 10 minutes!
▪ First read the product manufacturer's
instructions on inflating and the approved
maximum air pressure before inflating the
product.
▪ Open the product's valve cover.
▪ Attach the correct valve adapter to the flexible
pump hose and press it into the item's valve. If
the valve adapter detaches from the valve whilst
inflating, use your hand to press it into the valve
whilst inflating.
▪ Verify the valve adapter is securely connected to
the valve by carefully pulling on it.
▪ Now attach the free end of the flexible pump
hose onto the compressor's inflating valve
Be sure it is firmly seated.
▪ In this case setting the arrow marking on the
manometer adjusting ring
pressure will be ineffective!
▪ To switch on the compressor set the compressor
switch to ( I ). Note: the compressor can be
13
switched off at any time by setting the
compressor switch
13
▪ Observe and check the firmness of the item
whilst inflating. If the item has already been
overinflated, immediately interrupt the
process and switch the compressor off!
Attention! Excessive air pressure may
cause the item to burst! Risk of personal
injury and property damage!
▪ To completely switch the unit off simply set the
compressor switch to ( O ) and disconnect the
unit from the power supply. Automatic restart
warning! If the compressor On / Off switch is
set to ( I ) when reconnecting the unit to power
the compressor will automatically start and
compressed air will be blown through the air
hose and out the inflating valve and air sucked
in through the suction valve. Risk of property
damage and personal injury!
GB 25
15
to the desired air
5
to ( O ).
.