Hilti C 4/36-90 Mode D'emploi page 20

e) Do not touch the supply cord or extension cord if they are damaged
while working.
outlet. Damaged supply cords or extension cords present a risk of
electric shock.
f) Never operate the appliance when it is dirty or wet. Dust (especially
dust from conductive materials) or dampness adhering to the surface of
the appliance may, under unfavorable conditions, lead to electric shock.
Dirty or dusty appliances should thus be checked at a Hilti service
center at regular intervals, especially if used frequently for working on
conductive materials.
g) Do not use an extension cord with the C 4⁄36­DC charger. This
presents a risk of fire.
2.1.3 Personal safety
a) Do not wear jewelry such as rings or chains. Jewelry could cause a
short circuit and personal injury in the form of burns.
b) Take care to ensure that the charger is standing in a steady, secure
position. A falling battery or charger may present a risk of injury to
yourself and / or others.
c) Avoid touching the contacts.
d) Batteries that have reached the end of their life must be disposed
of safely and correctly to avoid environmental pollution.
e) This appliance is not intended for use by persons (including chil-
dren) with reduced physical, sensory or mental capabilities, or lack
of experience and knowledge, unless they have been given super-
vision or instruction concerning use of the appliance by a person
responsible for their safety.
f) Children must be instructed not to play with the appliance.
2.1.4 Battery charger use and care
a) Use the charger only to charge the specified Hilti batteries.
b) Maintain the appliance carefully. Check to ensure that no parts are
broken or damaged in such a way that the appliance can no longer
function correctly. If damaged, have the appliance repaired before
use.
c) Use chargers and the corresponding batteries in accordance with
these instructions and as is specified for this particular model. Use
of chargers for applications different from those intended could result in
hazardous situations.
d) When replacing the fuse in the cigarette lighter plug connector, use only
a replacement fuse of the same type as the original fuse (5x20 mm⁄
250 V⁄ 8A).
Printed: 18.01.2016 | Doc-Nr: PUB / 5069440 / 000 / 09
Disconnect the supply cord plug from the power
en
17